13 search results

• 
  How do I enable autologin on TTY running on the Gadget Mode serial port?
  The Cluster HAT allows you to log into the Pi Zeros via the (Gadget USB) Serial port, sometimes it's helpful ...
• 
  How do I create and copy the SSH key from the Controller Pi to the
  Assuming you haven't already created a public/private key on the Controller Pi run the following. ssh-keygen -t rsa Newer Raspberry Pi OS ...
• 
  [LEGACY] How do I setup usbboot (no SD cards in the Pi Zeros) for the
  See the current documentation on booting without SD cards, this legacy information is kept here in case it helps anyone. I ...
• 
  How do I copy SSH keys to P1-P4 when using usbboot/rpiboot?
  Since the filesystems for P1-P4 are stored on the Controller it's even easier to setup SSH keys to log into ...
• 
  How do I setup NAT on the WiFi interface on the rpiboot test images?
  WARNING: These steps relate to the OLD test rpiboot (only) images and NOT the current combined images, if you want ...
• 
  How do I USBBOOT Pi Zero/Pi Zero 2 without SD cards (Cluster HAT/Cluster CTRL)?
  With the Cluster CTRL images (linked from the ClusterHAT website) it's now possible to mix/match booting nodes (Pi Zeros/Compute Modules/A+) ...
• 
  ClusterCTRL: How to write an image to the eMMC?
  To write an image to the eMMC on a Compute Module you need to boot it as a USB Device ...
• 
  ClusterCTRL: How do I boot a Compute Module from eMMC?
  To boot a Compute Module from the eMMC USBBOOT must be disabled. If your Compute Module doesn't already have a bootable ...
• 
  What are the differences in Cluster HAT versions?
  Cluster HAT v1.0 USB connector: On left (SMT)Serial connector: THGPIO connector: Bottom entry + headerPower control: GPIOPower connector: 2 pin header ...
• 
  How do I use the solder jumpers on the Cluster HAT?
  Solder jumpers on the Cluster HAT allow you to modify the default behaviour and configuration. To change the configuration you ...
• 
  How do I manually install clusterctrl?
  If you're using one of the provided ClusterCTRL images the cluserctrl tool will already be installed but those using the ...
• 
  Can the Pi Zero 2 W be used in the Cluster HAT with a Pi5/Pi4?
  When using a Pi 5 and 4x Pi Zero 2 with the official 27W Pi 5 I wouldn't expect any ...
• 
  How do I use newer NCM images on older (bookworm) controllers?
  Images dated 2025-11-24-2 and earlier use the ACM+RNDIS protocols for the USB Gadget Ethernet. Images 2025-11-24-3 and later use ACM+NCM. ...